TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2150-03 Blade Left Lift Lever
4. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
Position Sensor Voltage
for continuity between cab lower
Replace implement 1 ECM (WP
Above Normal - Continued
wiring harness connector P-C41
0268).
(WP 0009, Figure 68) terminal 44
Remove jumper wire between cab
and machine ground.
lower wiring harness connector P-C51
Resistance should be less than
(WP 0009, Figure 118) terminal 1 and
5.0 ohms.
machine ground.
Connect cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J1 (WP
0282).
Proceed to step 5.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Proceed to step 5.
5. Using MSD (WP 0006), select
2150-03 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2150-03 is not active.
beginning.
2150-03 Code Not Active -
Troubleshooting complete.
Test Step 6. Test Signal Voltage to
Sensor.
1. Using digital multimeter, test for
Voltage Between 11.5 to 12.5 Volts -
voltage between harness connec-
Replace LH joystick (WP 0282).
tor P-C51 (WP 0009, Figure 118)
Proceed to step 2.
terminal 10 and terminal 8. Volt-
Voltage Out of Specifications of
age should be between 11.5 to
11.5 to 12.5 Volts - Proceed to Test
12.5 volts.
Step 7.
2150-03 Code Active - Repeat
2. Using MSD (WP 0006), select
troubleshooting code from the
Implement 120M ECM and verify
beginning.
2150-03 is not active.
2150-03 Code Not Active -
Troubleshooting complete.
Test Step 7. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0266).
0028-24