TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2150-08 Blade Left Lift Lever
Test Step 1. Test for Active Code.
Position Sensor Abnormal
Connect the MSD (WP 0006). Select
2150-08 Code Active - Proceed to
Frequency, Pulse Width or
Implement 120M and verify 2150-08
Test Step 2.
Period - Continued
is active.
2150-08 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Signal Voltage to
Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring har-
ness connector P-C51 (WP 0009,
Figure 118) from LH joystick con-
nector J1 (WP 0282).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
4. Using digital multimeter, test for
Voltage Between 11.5 to 12.5 Volts -
voltage between harness connec-
Replace LH joystick (WP 0282).
tor P-C52 (WP 0009, Figure 154)
Proceed to step 5.
terminal 10 and terminal 8
Voltage Out of Specifications of
ground. Voltage should be
11.5 to 12.5 Volts - Proceed to Test
between 11.5 to 12.5 volts.
Step 3.
5. Using MSD (WP 0006), select
2150-08 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2150-08 is not active.
beginning.
2150-08 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Connect jumper wire between cab
lower wiring harness connector P-
C51 (WP 0009, Figure 118) termi-
nal 8 and terminal 10.
0028-28