TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2147-04 Automatic Neutral
4. Using MSD (WP 0006), select
2147-04 Code Active - Repeat
Articulation Switch Voltage
Implement 120M ECM and verify
troubleshooting code from the
Below Normal - Continued
2147-04 is not active.
beginning.
2147-04 Code Not Active -
Troubleshooting complete.
System Response:
2150-03 Blade Left Lift Lever
Position Sensor Voltage
ECM will log diagnostic code.
Above Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test for Active Code.
1. Connect MSD (WP 0006). Select
0041-03 or 0041-04 Code Active -
Implement 120M ECM and check
Troubleshoot 0041-03 or 0041-04
if 0041-03 or 0041-04 is active.
code first before proceeding.
0041-03 or 0041-04 Code Not Active
- Proceed to step 2.
2. Using the MSD (WP 0006). Select 2150-03 Code Active - Proceed to
Implement 120M and verify 2150- Test Step 2.
03 is active.
2150-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test 8 Volt Power Sup-
ply Voltage to Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring har-
ness connector P-C51 (WP 0009,
Figure 118) from LH joystick con-
nector J1 (WP 0282).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
0028-21