TM 5-3805-293-23-2
0024
Table 1. Window Wipers and Washers Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. LH Door Wiper Does Not
Test Step 16. Test 118-GY Fused
Operate Properly - Con-
Wiper Washer Circuit for High
tinued
Resistance or Open in Cab Upper
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-293-10).
2. Disconnect cab lower wiring har-
ness connector P-C3 (WP 0009,
Figure 34) from cab upper wiring
harness connector R-C1 (WP
0009, Figure 33) (WP 0266).
3. Using digital multimeter, measure
Resistance 5.0 Ohms or Greater -
resistance between R-C1 terminal
Replace cab upper wiring harness
2 (WP 0009, Figure 33) and R-
(WP 0265).
C31 terminal 1 (WP 0009, Figure
Proceed to step 4.
367).
Resistance Less Than 5.0 Ohms -
Replace cab lower wiring harness
(WP 0266).
Connect R-C31 (WP 0009, Figure
367) on LH door wiper washer switch
(WP 0274).
Proceed to step 4.
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-3805-293-10).
5. Turn left door wiper/washer con-
Left Door Wiper Does Not Work in
trol to LOW, HIGH, and PARK
One Or More Positions Or Does Not
position (TM 5-3805-293-10).
Return To Park - Repeat trouble-
shooting from beginning.
Left Door Wiper Works In Low, and
High Position, and Returns to Park
- Troubleshooting complete.
Test Step 17. Test for Open LH Door
Wiper Washer Switch.
1. Disconnect cab upper wiring har-
ness connector R-C32 (WP 0009,
Figure 363) from RH door wiper
washer switch (WP 0274).
2. Connect cab upper wiring har-
ness connector R-C31 (WP 0009,
Figure 367) on RH door wiper
washer switch (WP 0274).
0024-40
