TM 5-3805-293-23-2
0024
Table 1. Window Wipers and Washers Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. LH Door Wiper Does Not
Test Step 13. Test 119-PK Fused
Operate Properly - Con-
Wiper Washer Circuit for Short to
tinued
Other Terminals in Wiper Wiring
Harness.
1. Disconnect wiper wiring harness
connector WK-C2 (WP 0009, Fig-
ure 370) from LH door wiper
motor (WP 0259).
2. Using digital multimeter, test for
No Continuity - Proceed to step 3.
continuity between WK-C2 termi-
Continuity - Replace wiper wiring
nal 6 and all other terminals in
harness (WP 0292).
WK-C2 (WP 0009, Figure 370).
Connect P-C3 (WP 0009, Figure 34)
on R-C1 (WP 0009, Figure 33) (WP
0266).
Connect R-C31 (WP 0009, Figure
367) on LH door wiper washer switch
(WP 0274).
Connect P-C74 (WP 0009, Figure
374) on LH door washer motor (WP
0261).
Install new fuse F1 on fuse box (TM 5-
3805-293-10).
Install cover on fuse box (TM 5-3805-
293-10).
Proceed to step 4
3. Using digital multimeter, test for
No Continuity - Proceed to Test Step
continuity between WK-C2 termi-
14.
nal 6 (WP 0009, Figure 370) and
Continuity - Replace wiper wiring
machine ground.
harness (WP 0292).
Connect P-C3 (WP 0009, Figure 34)
on R-C1 (WP 0009, Figure 33) (WP
0266).
Connect R-C31 (WP 0009, Figure
367) on LH door wiper washer switch
(WP 0274).
Connect P-C74 (WP 0009, Figure
374) on LH door washer motor (WP
0261).
Install new fuse F1 on fuse box (TM 5-
3805-293-10).
Install cover on fuse box (TM 5-3805-
293-10).
Proceed to step 4.
0024-35
