TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-02 Right Steering Cyl- 2.
Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
inder Position Sensor Data
resistance between right steering
Front attachment wiring harness is
Erratic, Intermittent or Incor-
cylinder position sensor wiring
open, replace front attachment wiring
rect - Continued
harness connector UC-C1 (WP
harness (WP 0180).
0009, Figure 198) terminal 3 and
Remove jumper wire from UC-C2
machine ground. Resistance
(WP 0009, Figure 196) terminal 2 and
should be less than 5.0 Ohms.
machine ground.
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C22 (WP 0009,
Figure 47) to cab lower wiring harness
P-C69 (WP 0009, Figure 46).
Proceed to step 3.
0020-81
