TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-02 Right Steering Cyl- 2.
inder Position Sensor Data
resistance between cab lower wir-
Rear chassis wiring harness is open,
Erratic, Intermittent or Incor-
ing harness connector P-C69
replace rear chassis wiring harness
rect - Continued
(WP 0009, Figure 46) terminal 48
(WP 0188).
and machine ground. Resistance
Remove jumper wire from UC-C2
should be less than 5.0 Ohms.
(WP 0009, Figure 196) terminal 2 and
machine ground.
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
Proceed to Test Step 5.
3. Using the MSD (WP 0006), select
2201-02 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2201-02 is not active.
2201-02 Code Not Active - Trouble-
shooting complete.
Test Step 5. Test for Open Front
Attachment Wiring Harness.
1. Disconnect the front attachment
wiring harness connector U-C1
(WP 0009, Figure 121) from cab
lower wiring harness P-C50 (WP
0009, Figure 120) (WP 0180).
0020-79