TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-03 Right Steering Cyl-
5. Connect UC-C2 (WP 0009, Fig-
inder Position Sensor Volt-
ure 196) to left steering position
age Above Normal -
sensor (WP 0009, Figure 193).
Continued
6. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
7. Using the MSD (WP 0006), select
2200-03 Code Becomes Active -
Trans/chassis 120M and check if
Disconnect UA-C2 (WP 0009, Figure
2200-03 becomes active.
192) from right steering position sen-
sor (WP 0009, Figure 197).
Disconnect UC-C2 (WP 0009, Figure
196) from left steering position sensor
(WP 0009, Figure 193).
Right steering position sensor is
faulty, replace right steering cylinder
(WP 0169).
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Proceed to step 8.
2201-03 Code Remains Active - Pro-
ceed to Test Step 3.
8. Using the MSD (WP 0006), select
2201-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2201-03 is not active.
2201-03 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect UA-C2 (WP 0009,
Figure 192) from right steering
position sensor (WP 0009, Figure
197).
3. Disconnect UC-C2 (WP 0009,
Figure 196) from left steering
position sensor (WP 0009, Figure
193).
0020-85