TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-02 Right Steering Cyl- 2.
inder Position Sensor Data
resistance between front attach-
Cab lower wiring harness is open,
Erratic, Intermittent or Incor-
ment wiring harness connector U-
replace cab lower wiring harness (WP
rect - Continued
C1 (WP 0009, Figure 121) termi-
0266).
nal 53 and machine ground.
Remove jumper wire from UC-C2
Resistance should be less than
(WP 0009, Figure 196) terminal 2 and
5.0 Ohms.
machine ground.
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 3.
Proceed to Test Step 6.
3. Using the MSD (WP 0006), select
2201-02 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2201-02 is not active.
2201-02 Code Not Active - Trouble-
shooting complete.
Test Step 6. Test for Open Front
Attachment Wiring Harness.
1. Disconnect the right steering cyl-
inder position sensor wiring har-
ness connector UC-C1 (WP 0009,
Figure 198) from front attachment
wiring harness U-C58 (WP 0009,
Figure 153) (WP 0136).
0020-80