TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-04 Left Steering Cylin-
6. Disconnect the rear chassis wir-
der Position Sensor Voltage
ing harness connector FA-C21
Below Normal - Continued
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
7. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
8. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
9. Using digital multimeter, measure
Continuity - Proceed to Test Step 3.
resistance between rear chassis
No Continuity - Proceed to Test Step
wiring harness connector FA-C21
6.
(WP 0009, Figure 124) terminal
15 and FA-C20 (WP 0009, Figure
113) terminal 70. There should be
no continuity.
Test Step 3. Test for Shorted Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness P-C69 (WP
0009, Figure 46).
2. Using digital multimeter, measure
Continuity - Proceed to Test Step 4.
resistance between cab lower wir-
No Continuity - Rear chassis wiring
ing harness connector P-C69
harness is shorted, replace rear chas-
(WP 0009, Figure 46) terminal 47
sis wiring harness (WP 0188).
and terminal 27. There should be
Connect the steering position sensor
no continuity.
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
0020-61
