TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-03 Left Steering Cylin-
Test Step 11. Test for Shorted Front
der Position Sensor Voltage
Attachment Wiring Harness.
Above Normal - Continued
1. Disconnect the left steering cylin-
der position sensor wiring har-
ness connector UA-C1 (WP 0009,
Figure 194) from front attachment
wiring harness U-C51 (WP 0009,
Figure 195) (WP 0136).
2. Using digital multimeter, measure
Continuity - Left steering cylinder
resistance between left steering
position sensor harness is open,
cylinder position sensor wiring
replace left steering position sensor
harness connector UA-C1 (WP
harness (WP 0136).
0009, Figure 194) terminal B and
Connect the steering position sensor
all other UA-C1 terminals. There
harness UA-C2 (WP 0009, Figure
should be no continuity.
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the front attachment wiring
harness connector U-C36 (WP 0009,
Figure 188) to cab lower wiring har-
ness P-C151 (WP 0009, Figure 189)
(WP 0180).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 3.
0020-56
