TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-04 Left Steering Cylin-
3. Using the MSD (WP 0006), select
2200-04 Code Active - Repeat trou-
der Position Sensor Voltage
Trans/chassis 120M and verify
bleshooting code from the beginning.
Below Normal - Continued
2200-04 is not active.
2200-04 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test for Shorted Front
Attachment Wiring Harness.
1. Disconnect the front attachment
wiring harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness P-C151 (WP
0009, Figure 189) (WP 0180).
2. Using digital multimeter, measure
Continuity - Proceed to Test Step 5.
resistance between front attach-
No Continuity - Cab lower wiring har-
ment wiring harness connector U-
ness is shorted, replace cab lower wir-
C36 (WP 0009, Figure 188) termi-
ing harness (WP 0266).
nal 2 and terminal 6. There should
Connect the steering position sensor
be no continuity.
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2200-04 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2200-04 is not active.
2200-04 Code Not Active - Trouble-
shooting complete.
Test Step 5. Test for Shorted Front
Attachment Wiring Harness.
1. Disconnect the left steering cylin-
der position sensor wiring har-
ness connector UA-C1 (WP 0009,
Figure 194) from front attachment
wiring harness U-C51 (WP 0009,
Figure 195) (WP 0136).
0020-62
