TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-03 Left Steering Cylin-
Test Step 7. Test for Open Cab
der Position Sensor Voltage
Lower Wiring Harness to Imple-
Above Normal - Continued
ment ECM.
1. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Proceed to Test Step 8.
ing harness connector P-C39
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 70) terminal 15
Cab lower wiring harness is open,
and P-C41 (WP 0009, Figure 68)
replace cab lower wiring harness (WP
terminal 70. Resistance should be
0266).
less than 5.0 Ohms.
Remove jumper wire from UA-C2 (WP
0009, Figure 192) terminal 2 and ter-
minal 3.
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 2.
2. Using the MSD (WP 0006), select
2200-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2200-03 is not active.
2200-03 Code Not Active - Trouble-
shooting complete.
Test Step 8. Test for Shorted Rear
Chassis Wiring Harness.
1. Remove jumper wire between
UA-C2 (WP 0009, Figure 192) ter-
minal 2 and terminal 3.
2. Using digital multimeter, measure
Continuity - Proceed to Test Step 9.
resistance between rear chassis
No Continuity- Proceed to Test Step
wiring harness connector FA-C21
12.
(WP 0009, Figure 124) terminal
15 and all other FA-C21 terminals.
There should be no continuity.
0020-53
