TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1674-05 Solenoid Return #1
4. Using the MSD (WP 0006), select
1674-05 Code Active - Repeat trou-
Current Below Normal -
Trans/chassis 120M and verify
bleshooting code from the beginning.
Continued
1674-05 is not active.
1674-05 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness connector P-
C69 (WP 0009, Figure 46).
2. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Rear chassis wiring harness is open,
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 13
(WP 0188).
and terminal 18.
Remove jumper wire between front
Resistance should be less than
chassis wiring harness connector U-
5.0 ohms.
C39 (WP 0009, Figure 186) terminal 1
and terminal 2.
Connect the front chassis wiring har-
ness connector U-C40 (WP 0009, Fig-
ure 190) to secondary steering right
solenoid (WP 0009, Figure 191) (WP
0216).
Connect the front chassis wiring har-
ness connector U-C39 (WP 0009, Fig-
ure 186) to secondary steering left
solenoid (WP 0009, Figure 187) (WP
0216).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 4.
3. Using the MSD (WP 0006), select
1674-05 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1674-05 is not active.
1674-05 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test for Open Front
Chassis Wiring Harness.
1. Disconnect the front chassis wir-
ing harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness connector P-
C151 (WP 0009, Figure 189).
0019-98