TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1961-03 Accumulator Pres-
2. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
sure Sensor Voltage Above
resistance between starter har-
Rear chassis wiring harness is open,
Normal - Continued
ness connector FH-C2 (WP 0009,
replace rear chassis wiring harness
Figure 135) terminal 1 and termi-
(WP 0188).
nal 2.
Remove jumper wire between starter
Resistance should be less than
harness connector FG-C2 (WP 0009,
5.0 ohms.
Figure 137) terminal A and terminal B.
Connect the starter FG-C2 (WP 0009,
Figure 137) to service brake accumu-
lator pressure sensor (WP 0009, Fig-
ure 138).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Starter wiring harness is open,
replace starter wiring harness (WP
0065).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) from transmission ECM
J1 (WP 0009, Figure 112).
Proceed to step 3.
3. Using the MSD (WP 0006), select
1961-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1961-03 is not active.
1961-03 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test for Open Rear
Chassis Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
2. Connect jumper wire between
starter harness connector FG-C2
(WP 0009, Figure 137) terminal B
and terminal C.
0019-102