TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1482-03 10 Volt Sensor DC
3. Using digital multimeter, test for
Continuity - Proceed to Test Step 4.
Power Supply Voltage
continuity between rear chassis
No Continuity - Replace transmis-
Above Normal - Continued
wiring harness connector FA-C20
sion ECM (WP 0137).
(WP 0009, Figure 113) terminal
Connect the cab lower wiring harness
69 and terminal 70. There should
connector P-C8 (WP 0009, Figure 50)
be no continuity.
to RH joystick connector J-1 (WP
0283).
Connect the steering position sensor
harness connector UA-C2 (WP 0009,
Figure 192) to left steering position
sensor (WP 0009, Figure 193) (WP
0136). Proceed to step 4.
4. Using the MSD (WP 0006), select
1482-04 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1482-04 is not active.
1482-04 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test for Shorted Cab
Lower Wiring Harness.
1. Disconnect the cab lower wiring
harness connector P-C71 (WP
0009, Figure 18) (WP 0266) from
rear chassis wiring harness con-
nector FA-C23 (WP 0009, Figure
17).
2. Using digital multimeter, test for
Continuity - Proceed to Test Step 5.
continuity between cab lower wir-
No Continuity - Rear chassis wiring
ing harness connector P-C71
harness shorted, replace rear chassis
(WP 0009, Figure 18) terminal 1
wiring harness (WP 0188).
and terminal 2. There should be
Connect the cab lower wiring harness
no continuity.
connector P-C8 (WP 0009, Figure 50)
to RH joystick connector J-1 (WP
0283).
Connect the steering position sensor
harness connector UA-C2 (WP 0009,
Figure 192) to left steering position
sensor (WP 0009, Figure 193) (WP
0136). Proceed to step 3.
1482-04 Code Active - Repeat trou-
3. Using the MSD (WP 0006), select
bleshooting code from the beginning.
Trans/chassis 120M and verify
1482-04 is not active.
1482-04 Code Not Active - Trouble-
shooting complete.
0019-78