TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0596-12 Implement Control
9. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
Bad Device or Component -
continuity between harness con-
Proceed to step 10.
Continued
nector P-C41 (WP 0009, Figure
Resistance 5.0 Ohms or More -
68) terminal 27 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Resistance should be less than
Proceed to step 15.
5.0 ohms.
10. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 11.
nector P-C41 (WP 0009, Figure
Resistance 5.0 Ohms or More -
68) terminal 32 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Resistance should be less than
Proceed to step 15.
5.0 ohms.
11. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 12.
nector P-C41 (WP 0009, Figure
Resistance 5.0 Ohms or More -
68) terminal 56 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Resistance should be less than
Proceed to step 15.
5.0 ohms.
12. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 13.
nector P-C41 (WP 0009, Figure
Resistance 5.0 Ohms or More -
68) terminal 57 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Resistance should be less than
Proceed to step 15.
5.0 ohms.
13. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 14.
nector P-C41 (WP 0009, Figure
Resistance 5.0 Ohms or More -
68) terminal 70 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Resistance should be less than
Proceed to step 15.
5.0 ohms.
14. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to Test Step 4.
nector P-C41 (WP 0009, Figure
Resistance 5.0 Ohms or More -
68) terminal 13 and machine
Replace cab lower wiring harness
ground.
(WP 0266).
Resistance should be less than
Proceed to step 15.
5.0 ohms.
15. Using MSD (WP 0006), select
0596-12 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0596-12 is not active.
diagnostic code.
0596-12 Code Not Active - Trouble-
shooting complete.
0017-29