TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0596-09 Implement Control
9. Using digital multimeter, test for
Continuity - Proceed to step 10.
Module Abnormal Update
continuity between harness con-
No Continuity - Replace cab lower
Rate - Continued
nector P-C41 (WP 0009, Figure
wiring harness (WP 0266).
68) terminal 27 and machine
Proceed to step 15.
ground.
There should be no continuity.
10. Using digital multimeter, test for
Continuity - Proceed to step 11.
continuity between harness con-
No Continuity - Replace cab lower
nector P-C41 (WP 0009, Figure
wiring harness (WP 0266).
68) terminal 32 and machine
Proceed to step 15.
ground.
There should be no continuity.
11. Using digital multimeter, test for
Continuity - Proceed to step 12.
continuity between harness con-
No Continuity - Replace cab lower
nector P-C41 (WP 0009, Figure
wiring harness (WP 0266).
68) terminal 56 and machine
Proceed to step 15.
ground.
There should be no continuity.
12. Using digital multimeter, test for
Continuity - Proceed to step 13.
continuity between harness con-
No Continuity - Replace cab lower
nector P-C41 (WP 0009, Figure
wiring harness (WP 0266).
68) terminal 57 and machine
Proceed to step 15.
ground.
There should be no continuity.
13. Using digital multimeter, test for
Continuity - Proceed to step 14.
continuity between harness con-
No Continuity - Replace cab lower
nector P-C41 (WP 0009, Figure
wiring harness (WP 0266).
68) terminal 70 and machine
Proceed to step 15.
ground.
There should be no continuity.
14. Using digital multimeter, test for
Continuity - Proceed to Test Step 4.
continuity between harness con-
No Continuity - Replace cab lower
nector P-C41 (WP 0009, Figure
wiring harness (WP 0266).
68) terminal 13 and machine
Proceed to step 15.
ground.
There should be no continuity.
15. Using MSD (WP 0006), select
0596-09 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0596-09 is not active.
diagnostic code.
0596-09 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test Data Link Circuit.
1. Disconnect harness connector
FA-C20 (WP 0009, Figure 113)
from transmission ECM J1 (WP
0009, Figure 112).
0017-23