TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0596-09 Implement Control
6. Using digital multimeter, test for
Voltage 18 to 26 Volts - Proceed to
Module Abnormal Update
Voltage between harness connec-
step 7.
Rate - Continued
tor P-C41 (WP 0009, Figure 68)
Voltage Less Than 18 Volts -
terminal 31 and machine ground.
Replace cab lower wiring harness
Voltage should be 18 to 26 volts.
(WP 0266).
Proceed to step 9.
7. Using digital multimeter, test for
Voltage 18 to 26 Volts - Proceed to
Voltage between harness connec-
step 8.
tor P-C41 (WP 0009, Figure 68)
Voltage Less Than 18 Volts -
terminal 38 and machine ground.
Replace cab lower wiring harness
Voltage should be 18 to 26 volts.
(WP 0266).
Proceed to step 9.
8. Using digital multimeter, test for
Voltage 18 to 26 Volts - Proceed to
Voltage between harness connec-
Test Step 3.
tor P-C41 (WP 0009, Figure 68)
Voltage Less Than 18 Volts -
terminal 46 and machine ground.
Replace cab lower wiring harness
Voltage should be 18 to 26 volts.
(WP 0266).
Proceed to step 9.
9. Using MSD (WP 0006), select
0596-09 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0596-09 is not active.
diagnostic code.
0596-09 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test Ground Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
2. Remove rear bulkhead cover
plate (WP 0266).
3. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
0017-21