TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0444-03 Starter Motor Relay
5. Using digital multimeter, test for
Continuity - Replace rear chassis
Voltage Above Normal -
continuity between harness con-
wiring harness (WP 0188).
Continued
nector FA-C21 (WP 0009, Figure
Proceed to step 6.
124) terminal 2 and all other ter-
No Continuity - Replace circuit
minals on harness connector FA-
breaker box wiring harness (WP
C21. There should be no continu-
0239).
ity.
Connect harness connector FA-C41
(WP 0009, Figure 21) to circuit
breaker box harness connector R-C5
(WP 0009, Figure 22) (WP 0234).
Proceed to step 6.
6. Using MSD (WP 0006), select
0444-03 Code Active - Repeat trou-
Trans/Chassis 120M ECM and
bleshooting code from the beginning.
verify 0444-03 is active.
0444-03 Code Not Active - Trouble-
shooting complete.
0444-05 Starter Motor Relay
System Response:
Current Below Normal
Starter motor will not operate.
ECM will log diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test Relay Control.
1. Connect MSD (WP 0006). Select
Trans/Chassis 120M ECM and
verify 0444-05 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
3. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112) (WP 0137).
4. Disconnect harness connector
FA-C41 (WP 0009, Figure 21)
from circuit breaker box harness
connector R-C5 (WP 0009, Figure
22) (WP 0234).