TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0420-05 Secondary Steering
3. Disconnect secondary steering
Relay Current Below Nor-
relay harness connector FA-C50
mal - Continued
(WP 0009, Figure 126) from sec-
ondary steering relay (WP 0009,
Figure 125) (WP 0188).
4. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112) (WP 0137).
5. Install jumper wire between sec-
ondary steering relay harness
connector FA-C50 (WP 0009, Fig-
ure 126) terminal 2 and terminal
5.
6. Using digital multimeter, test for
Continuity - Replace secondary
continuity between harness con-
steering relay (WP 0189).
nector FA-C21 (WP 0009, Figure
Connect harness connector FA-C21
124) terminal 2 and terminal 4.
(WP 0009, Figure 124) to transmis-
Resistance should be less than 5.0
sion ECM J2 (WP 0009, Figure 112)
ohms.
(WP 0137).
Proceed to step 10.
No Continuity - Proceed to step 7.
7. Remove jumper wire from sec-
ondary steering relay harness
connector FA-C50 (WP 0009, Fig-
ure 126) terminal 2 and terminal
5.
8. Using digital multimeter, test for
Continuity - Proceed to step 9.
continuity between harness con-
No Continuity - Replace rear chassis
nector FA-C21 (WP 0009, Figure
wiring harness (WP 0188).
124) terminal 5 and secondary
Proceed to step 10.
steering relay harness connector
FA-C50 (WP 0009, Figure 126)
terminal 5.
Resistance should be less than 5.0
ohms.
0016-51