TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-04 8 Volt DC Supply
17. Using MSD select Trans/Chassis
0041-04 Becomes Active - Replace
Voltage Below Normal - Con-
120M ECM and monitor diagnos-
right articulation angle position sensor
tinued
tic code 0041-04 while connecting
(WP 0257).
harness connector AT-C4 (WP
Connect harness connector P-C40
0009, Figure 122) to right articula-
tion angle position sensor (WP
0009, Figure 123) (WP 0257).
ure 145) (WP 0257).
Install inching pedal assembly cover
(WP 0290).
Connect harness connector P-C48
Install inner panel cover on joystick
support (WP 0282).
Install operator's seat (WP 0284).
Install rear bulkhead cover plate (WP
0266).
Proceed to step 19.
0041-04 is Not Active - Proceed to
step 18.
18. Using MSD select Trans/Chassis
0041-04 is Not Active - Replace left
120M ECM and monitor diagnos-
hand joystick (WP 0282).
tic code 0041-04 while connecting
Install rear bulkhead cover plate (WP
harness connector P-C40 (WP
0266).
0009, Figure 144) to inching pedal
Connect harness connector AT-C4
145) (WP 0257).
lation angle position sensor (WP
0009, Figure 123) (WP 0257).
Proceed to step 19.
0041-04 Becomes Active - Replace
inching pedal position sensor (WP
0290).
Connect harness connector P-C48
Install inner panel cover on joystick
support (WP 0282).
Install operator's seat (WP 0284).
Install rear bulkhead cover plate (WP
0266).
Proceed to step 19.
0016-8