TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-03 8 Volt DC Supply
17. Using MSD select Trans/Chassis
0041-03 Becomes Active - Replace
Voltage Above Normal -
120M ECM and monitor diagnos-
right articulation angle position sensor
Continued
tic code 0041-04 while connecting
(WP 0257).
harness connector AT-C4 (WP
Connect harness connector P-C40
0009, Figure 122) to right articula-
(WP 0009, Figure 144) to inching
tion angle position sensor (WP
pedal position sensor (WP 0009, Fig-
0009, Figure 123) (WP 0257).
ure 145) (WP 0257), and install pedal
assembly cover (WP 0290)
Connect harness connector P-C48
(WP 0009, Figure 116) on left hand
joystick J3 (WP 0009, Figure 117)
Install inner panel cover on joystick
support (WP 0282).
Install operator's seat (WP 0284).
Install rear bulkhead cover plate (WP
0266).
Proceed to step 19.
0041-03 is Not Active - Proceed to
step 18.
18. Using MSD select Trans/Chassis
0041-03 is Not Active - Replace left
120M ECM and monitor diagnos-
hand joystick (WP 0282).
tic code 0041-04 while connecting
Install rear bulkhead cover plate (WP
harness connector P-C40 (WP
0266).
0009, Figure 144) to inching pedal
Connect harness connector AT-C4
position sensor (WP 0009, Figure
(WP 0009, Figure 122) to right articu-
145) (WP 0257).
lation angle position sensor (WP
0009, Figure 123) (WP 0257).
Proceed to step 19.
0041-03 Becomes Active - Replace
inching pedal position sensor (WP
0290).
Connect harness connector P-C48
(WP 0009, Figure 116) on left hand
joystick J3 (WP 0009, Figure 117)
Install inner panel cover on joystick
support (WP 0282).
Install operator's seat (WP 0284).
Proceed to step 19.
19. Using MSD (WP 0006), select
0041-03 Code Active - Repeat trou-
Trans/Chassis 120M ECM and
bleshooting code from the beginning.
verify 0041-03 is active.
0041-03 Code Not Active - Trouble-
shooting complete.
0016-4