TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-03 8 Volt DC Supply
Test Step 2. Test Secondary Steer-
Voltage Above Normal -
ing Sensor Harness.
Continued
1. Disconnect harness connector
FA-C5 (WP 0009, Figure 111)
from harness connector AT-C1
(WP 0009, Figure 110) (WP
0186).
2. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between harness con-
wiring harness (WP 0188).
nector FA-C20 (WP 0009, Figure
Connect harness connector AT-C4
113) terminal 44 and all other ter-
(WP 0009, Figure 122) to right articu-
minals on FA-C20.
lation angle position sensor (WP
0009, Figure 123) (WP 0257).
Connect harness connector FA-C23
(WP 0009, Figure 17) to harness con-
nector P-C71 (WP 0009, Figure 18),
and install rear bulkhead connection
cover (WP 0266).
Proceed to step 3.
No Continuity - Replace secondary
steering harness (WP 0186).
Connect harness connector FA-C20
(WP 0009, Figure 113) to transmis-
sion ECM J1 (WP 0137).
Connect harness connector AT-C4
(WP 0009, Figure 122) to right articu-
lation angle position sensor (WP
0009, Figure 123) (WP 0257).
Connect harness connector FA-C23
(WP 0009, Figure 17) to harness con-
nector P-C71 (WP 0009, Figure 18),
and install rear bulkhead connection
cover (WP 0266).
Proceed to step 3.
3. Using MSD (WP 0006), select
0041-03 Code Active - Repeat trou-
Trans/Chassis 120M ECM and
bleshooting code from the beginning.
verify 0041-03 is active.
0041-03 Code Not Active - Trouble-
shooting complete.
0016-5