TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-08 All-Wheel Drive
4. Check for Active code 2194-04 in
Code 2194-04 Becomes Active -
(AWD) Control Dial Position
All Wheel Drive 120M ECM (WP
Remove jumper wire from R-C12 ter-
Sensor Abnormal Fre-
minal C and terminal B (WP 0009,
quency, Pulse Width, or
Figure 88).
Period - Continued
Replace AWD control dial position
sensor (WP 0271).
Proceed to step 5.
Code 2194-04 Does Not Become
Active - Proceed to Test Step 7.
5. Using the MSD (WP 0006), select
2194-08 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-08 is not active.
2194-08 Code Not Active - Trouble-
shooting complete.
Test Step 7. Test G858-OR Signal
Circuit Resistance in Cab Upper
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. If jumper wire is installed, remove
jumper wire from R-C12 terminal
C and terminal B (WP 0009, Fig-
ure 88).
3. Disconnect cab lower wiring P-
C42 harness connector (WP
0009, Figure 90) from cab upper
wiring R-C3 harness connector
(WP 0009, Figure 91) (WP 0266).
4. Disconnect cab lower wiring P-C3
harness connector (WP 0009,
Figure 34) from cab upper wiring
R-C1 harness connector (WP
0009, Figure 33) (WP 0266).
5. Using a digital multimeter, mea-
Resistance Less Than 0.3 ohm -
sure resistance between R-C1
Proceed to Test Step 8.
terminal 53 (WP 0009, Figure 33)
Resistance 0.3 ohm or Greater -
and R-C12 terminal C (WP 0009,
Replace cab upper wiring harness
Figure 88).
(WP 0265).
Proceed to step 6.
6. Using the MSD (WP 0006), select
2194-08 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2194-08 is not active.
2194-08 Code Not Active - Trouble-
shooting complete.
0013-127