TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2194-04 All-Wheel Drive
5. Using the MSD (WP 0006), select
2194-04 Code Active - Repeat trou-
(AWD) Control Dial Position
All Wheel Drive 120M and verify
bleshooting code from the beginning.
Sensor Voltage Below Nor-
2194-04 is not active.
2194-04 Code Not Active - Trouble-
mal - Continued
shooting complete.
Test Step 6. Test G858-OR Signal
Circuit for Short to Implement 2 Cir-
cuits in Cab Lower Wiring Harness.
1. Disconnect cab lower wiring P-
C45 harness connector (WP
0009, Figure 72) from Implement
2 ECM J1 (WP 0009, Figure 73)
(WP 0268).
2. Disconnect cab lower wiring P-
C27 harness connector (WP
0009, Figure 74) from Implement
2 ECM J2 (WP 0009, Figure 75)
(WP 0268).
3. Using a digital multimeter, test for
No Continuity on Any Test Points -
continuity between P-C37 termi-
Proceed to step 4.
nal 26 (WP 0009, Figure 55) and
Continuity on One or More Test
all circuits in P-C45 (WP 0009,
Points - Replace cab lower wiring
Figure 72). There should be no
harness (WP 0266).
continuity.
Connect R-C12 (WP 0009, Figure 88)
on AWD control dial position sensor
connector (WP 0009, Figure 89) (WP
0271).
Proceed to step 5.
4. Using a digital multimeter, test for
No Continuity on Any Test Points -
continuity between P-C37 termi-
Replace AWD ECM (WP 0270).
nal 26 (WP 0009, Figure 55) and
Connect P-C41 (WP 0009, Figure 68)
all circuits in P-C27 (WP 0009,
on Implement 1 ECM J1 (WP 0009,
Figure 74). There should be no
Figure 69) (WP 0268).
continuity.
Connect P-C39 (WP 0009, Figure 70)
on Implement 1 ECM J2 (WP 0009,
Figure 71) (WP 0268).
Connect P-C45 (WP 0009, Figure 72)
on Implement 2 ECM J1 (WP 0009,
Figure 73) (WP 0268).
Connect P-C27 (WP 0009, Figure 74)
on Implement 2 ECM J2 (WP 0009,
Figure 75) (WP 0268).
Connect P-C3 (WP 0009, Figure 34)
on R-C1 (WP 0009, Figure 33) (WP
0266).
0013-122