TM 5-3805-293-23-1
0011
Table 2. Engine Troubleshooting with Codes for the 120M Motor Grader - Continued.
CDI FMI CODE
ERROR/EVENT
CORRECTIVE ACTION
2417-05 Ether Injection Con- 2. Remove jumper wire from ether
trol Solenoid Current Below
valve solenoid harness connector
Normal Code - Continued
FE-C2 (WP 0009, Figure 37) ter-
minal 1 and ground.
3. Install a jumper wire between
ether valve solenoid harness con-
nector FE-C2 (WP 0009, Figure
37) terminal 1 and terminal 2.
4. Disconnect harness connector
FE-C1 (WP 0009, Figure 27) from
harness connector FA-C18 (WP
0009, Figure 28).
5. Using a digital multimeter, test for
No Continuity - Fuel wiring harness
continuity between harness con-
is open, replace fuel wiring harness
nector FE-C1 (WP 0009, Figure
(WP 0064).
27) terminal 4 and 6.
Remove jumper wire from FE-C2 ter-
minal 1 and terminal 2.
There should be good continuity.
Continuity - (Resistance should be
less than 5.0 Ohms) - Proceed to Test
Step 4.
Test Step 4. Rear Chassis Wiring
Harness Test.
1. Remove jumper wire from FE-C2
terminal 1 and terminal 2.
2. Install a jumper wire between har-
ness connector FA-C18 (WP
0009, Figure 28) terminal 4 and
terminal 6.
3. Disconnect engine ECM harness
connector FA-C17 (WP 0009, Fig-
ure 14) from Engine ECM J1.
0011-180