POWER TRAIN
DISASSEMBLY AND ASSEMBLY
61.
62.
63.
64.
65.
66.
67.
68.
69.
70.
TRANSMISSION
Install a 3/8”-16 NC forged eyebolt in the
cover for the transfer gears as shown.
Install tooling (G) in the eyebolt.
Install tooling (F) on the transmission and
on the transmission hydraulic control valves
as shown. Connect tooling (G) to tooling
(F) on the control valves.
Put transmission hydraulic control valves
(84) in position on the transmission.
Install bolts (85) and bolts (87) that hold
the transmission hydraulic control valves to
the transmission. Tighten the bolts to a
torque of 35 ± 3 lb. ft. (4.8 ± 0.4 mkg).
Push four sleeves (86) into their correct
locations in the control valves.
Install plates (89) in their correct locations
in the grooves of sleeves (86). Install bolts
(88) that hold the sleeves and the plates.
Tighten bolts (88) to a torque of 22 ± 3 lb.
ft. (3.0 ± 0.4 mkg).
Put links (90) in position in stems (91) for
the control valves. Tighten the links.
Put the gasket and cover (93) in position on
the side of the transmission.
Install bolts (92) that hold the cover to the
transmission.
end by:
a) install transmission
TM 5-3805-263-14&P-2
2-105
