POWER TRAIN
DISASSEMBLY AND ASSEMBLY
TM 5-3805-263-14&P-2
BRAKE AND WHEEL SPINDLE HOUSINGS
REMOVE BRAKE AND WHEEL SPINDLE
HOUSINGS
Tools Needed
8S9906 Ratchet Assembly
A
1
1.
2.
3.
4.
5.
start by:
a) remove drive chains
Release the air pressure in the air tank by
loosening the bleed valves.
WARNING: Do not disconnect the air line
to the brake and wheel spindle housing until
the air pressure is zero.
Remove two nuts (2), the washers and
guard ( 1) from the housing.
Disconnect the air line from the housing
and the block on the tandem housing.
Remove the air line.
Fasten a hoist and tooling (A) to the plate
on the brake and wheel spindle housing and
to the stud on the wheel spindle.
Remove nuts (3) and the washers that hold
the brake and wheel spindle housing to the
tandem housing. Remove brake and wheel
spindle housing (4). Weight is 350 lb. (159
kg).
INSTALL BRAKE AND WHEEL SPINDLE
HOUSINGS
Tools Needed
A
8S9906 Ratchet Assembly
1
1. Fasten a hoist and tooling (A) to the brake
and wheel spindle housing. Put brake and
wheel spindle housing (1) in position on the
studs in tandem housing (2).
2. Install the nuts (3) and the washers that
hold the brake and wheel spindle housing to
the tandem housing.
3. Remove the hoist and tooling (A). Install
the air line on the brake and wheel spindle
housing and the block on the tandem
housing. Install the guard on the housing.
Install the two nuts and the washers that
hold it.
end by:
a) install drive chains
2-47
