3304 VEHICULAR ENGINESTM 5-3805-263-14&P-2SPECIFICATIONSCONNECTING ROD ASSEMBLY8N1721(1)Bore in bearing for piston pin(new) . . . . . . . . . 43.210 ± 0.008 mm (1.7012 ± .0003 in.)Diameter of piston pin(new). . . . . . . . . . .43.175 ± 0.005 mm (l.6998 ± .0002 in.)Maximum permissible clearance between bearing andpiston pin (worn). . . . . . . . . . . . . . . . . 0.08 mm (.003 in.)(2)Bore in connecting rod forbearing . . . . . . . . . 82.550 ± 0.013 mm (3.2500 ± .0005 in.)(3)Distance between center of piston pinand center of crankshaft bearing(new) . . . . . . . . . .243.71± 0.03 mm (9.595 ± .001 in.)(4)Torque on nut for connecting rod:a. Put engine oil on threads and nut seat.b. Tighten both nuts to . . . . . . . . . . 40 ± 4 N•m (30 ± 3 lb. ft.)c. Mark each nut and end of bolt.d. Again tighten both nuts (from mark) . . . . . . . . . . . . . . . . . . . . . . . . . . .90°Install the connecting rod in the piston with the slot for the bearing tabon the same side as the V mark on the piston.1-242
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
