3304 VEHICULAR ENGINES
SPECIFICATIONS
TM 5-3805-263-14&P-2
OIL BREATHER CAP
1P4244
(1) Torque for bolt holding
breather cap . . . . . . . . . . . . . . . . . . . 120 ± 24 lb. in. (14 ± 3 N·m)
WATER PUMP-GROUP
7N6206
(1) Oil seal. Put engine oil on the seal lip. Assemble with the lip
toward the bearings.
(2) Water seal and ring.
a. Put water on the seal.
b. Install the seal and ring together in the housing bore, with the
shiny face of the ring outside.
(3) Seal assembly.
a. Remove the spring from the seal.
b. Put water inside the seal assembly.
c. Install the seal assembly around the shaft, with the 7N7843
Installation Tool, (the tool is with the seal group) until the car.
bon face makes contact with the shiny face of the ring (2).
d. Install the spring.
(4)
Torque for the bolt that holds the
impeller
28 ± 1 lb. ft. (38 ± 1.5 N·m)
(5) Torque for bolt that holds the
gear
72 ± 5 lb. ft. (97 ± 7 N·m)
1-237
