ENGINEDISASSEMBLY AND ASSEMBLYTM 5-3805-263-14&P-2PUMP GROUP DRIVE SHAFTREMOVE PUMP GROUP DRIVE SHAFT1. Remove bolts (1) and (3) from each side ofguards (2). Remove guards (2).2. Remove bolts (4) that hold the drive shaft to theyoke on the hydraulic pump.3. Remove bolt (5) that holds the drive shaft to theyoke on the engine.4.Remove drive shaft.INSTALL PUMP GROUP DRIVE SHAFT1. Put drive shaft (1) in position between the yokeon the hydraulic pump and the yoke on theengine.2. Install the bolts that hold the driveshaft to thehydraulic pump. Tighten the bolts to a torqueof 40 ± 5 lb.ft. (55 ± 7 N•m).3. Install the bolts that hold the drive shaft to theengine. Tighten the bolts to a torque of 40 ± 5lb.ft. (55 ± 7 N•m).4. Put guards (2) in position over the pumpgroup drive shaft and on the frame. Installbolts that hold the guards to the frame. Installbolts that hold the guards to each other.1-179
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
