Test the Supplemental Steering

Before Starting the Engine - TM-5-3805-263-14P-1_34

Before Starting the Engine - TM-5-3805-263-14P-1_36

TM-5-3805-263-14P-1 Grader Heavy Road Motorized Diesel Engine Driven Type I (Nonsectionalized) Type II (Sectionalized) Manual
Page Navigation
31

TM 5-3805-263-14&P-1 Check the radiator coolant level. Keep the coolant level above the low fluid level mark and up to the full mark. Test the Supplemental Steering A dead cell in the machine’s batteries will result in a loss of supplemental steering capability. NOTICE Hold the switch in the MANUAL position only long enough to test the supplemental steering. Do not exceed five minutes. Allow the pump and solenoid to cool. To Test 1. Turn the disconnect switch ON. 2. The steering fault indicator should blink and the fault light should flash until the engine is started. The motor indicator should go ON for three seconds. NOTE: While the motor indicator is ON, the effort required to steer the machine should be nearly the same as the effort required when using the machine’s primary steering system. 3. Start the engine. The steering fault indicator and fault light should go OFF. 33

Privacy Statement
Press Release
Contact