REAR AXLE MAINTENANCE. (cont.) - TM-5-3805-261-34

REAR AXLE MAINTENANCE. (cont.) - TM-5-3805-261-34_994

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
948

TM 5-3805-261-34 REAR AXLE MAINTENANCE. 14-18. Differential Carrier. (Sheet 7 of 7) ASSEMBLY 19. Insert two .250 inch dowels in splines of shaft (11) 180 degrees apart. Install socket over shaft (11) and two dowels (Figure 14-146). 20. Using socket and torque wrench, check amount of torque needed to move shaft (11, Figure 14-147) without preload. 21. Using ratchet, hold shaft (11) while tightening nut (8) to 6 in-lb torque above the measured torque without preload. 22. Remove socket from shaft (11). 23. Bend tabs of lock (9) over nut (8). 24. Install new preformed packings (7 thru 3, Figure 14-148). 25. Install tubes (2 and 1) in carrier (31). 26. Install differential assembly and bearing cap. Refer to paragraph 14-17, steps 2 thru 13. NOTE Return 130G Grader to original equipment condition. Figure 14-147. Figure 14-146. Figure 14-148. End of Task 14-107

Privacy Statement
Press Release
Contact