TM 5-3805-261-34REAR AXLE MAINTENANCE. (cont)14-18. DifferentialCarrier. (Sheet 6 of 7)ASSEMBLY (cont)11. Heat cone bearing (12) in oil to275 degrees F and install onshaft (11, Figure 14-143).12. Position shaft (11, Figure14-144) on wood block.13. Attach bracket to carrier (31)and hoist and chain to bracket.WARNINGUse adequate hoist and chainfor lifting. Failure tofollow this procedure maycause INJURY. If you areinjured, seek medical aidimmediately.14. Using hoist and chain, positioncarrier (31) on shaft (11),seating in cup (13).15. Heat cone bearing (15) in oil to275 degrees F and install onshaft (11), seating in cup (16,Figure 14-145).16. Using hoist and chain, raisecarrier (31) and remove woodblock.17. Remove hoist and chain andbracket from carrier (31).18. Install washer (10), lock (9) andnut (8). Do not tighten nut (8).Figure 14-143.Figure 14-144.Figure 14-145.Go to Sheet 714-106
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business