TM 5-3805-261-34
TRANSMISSION MAINTENANCE. (cont.)
14-10. Selector and Differential Control Valve. (Sheet 5
of 6)
NSPECTION (cont.)
12. Measure spring (21) free length. Length should be
0.431 inch.
13. Apply compression load of 10.5 to 12.3 lb. to spring
(24).
14. Measure spring (24). Length should be 0.686 inch.
15. Measure spring (24) free length. Length. should be
0.877 inch.
16. Apply compression load of 2.04 to2.40 lb. to spring
(25).
17. Measure spring (25). Length should be 0.967 inch.
18. Measure spring (25) free length. Length should be
1.139 inches.
19. Inspect all other parts. Refer to Chapter 2.
ASSEMBLY
1. Install eight dampers (32), four dowels (31) and two
plugs (30) in body (33, Figure 4-96).
2
Install stop (29) and dowel (28). Dowel (28) must
be installed 0.190 inch beneath face of body (33).
3.
Install slug (27) in piston (26, Figure 14-95).
4.
Install piston (26), springs (25 and 24), sleeve (23),
spool (22) and spring (21).
5.
Install spring (20) and spool (19, Figure 14-98).
Figure 14-98.
Figure 14-95.
Figure 14-96.
Go to Sheet 6
14-68
