ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_843

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_845

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
797

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 13-4. Crankshaft Assembly. (Sheet 3 of 5) REMOVAL 1. Install 3/4-16NC bolt into gear end of crankshaft (Figure 13-11). 2. Install two 5/8-18NF bolts into flywheel end (rear) of crankshaft (3). WARNING Weight of crankshaft assembly is approximately 145 lbs. Use adequate hoist and sling for lifting. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 3. Install hoist and sling on three bolts in crankshaft (3). 4. Remove crankshaft (3). 5. Remove hoist and sling from crankshaft (3). 6. Using puller assembly, ratchet box wrench, step plate and bearing puller attachment, remove crankshaft gear (1) from crank- shaft (3, Figure 13-12). 7. Remove four plugs (2). Figure 13-11. Figure 13-12. Go to Sheet 4 13-18

Privacy Statement
Press Release
Contact