TM 5-3805-261-34
GAGES (NON-ELECTRICAL) MAINTENANCE. (cont)
11-2.
Air Pressure Gage to Air Tank Lines and Fittings. (Sheet 2 of 7)
REMOVAL
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
1.
Disconnect hose assembly (12,
Figure 11-1) from air tank under
rear, right side of vehicle.
2.
Remove connector (1) from air
tank fitting.
3.
Extract electrical lead from
bracket on right, rear frame,
near alternator and move lead out
of way to gain access to bolt (2,
Figure 11-2).
4.
Remove bolt (2), washer (3) and
clip (4).
5.
Remove bolt (5), washer (6) and
clip (7, Figure 11-3) from right
side of engine compartment.
Go to Sheet 3
11-4
Figure 11-1.
Figure 11-2.
Figure 11-3.
