TM 5-3805-261-34
BRAKES MAINTENANCE. (cont)
6-8.
Air Brake Control. (Sheet 2 of 4)
REMOVAL
1.
Remove two bolts (1), washers
(2), thread (3). washer (4) and
boot (5, Figure 6-14) from right
side of cab floor.
2.
Remove setscrew (6) and nut (7)
from base.
3.
Remove spring (8), nut (9), bolt
(10) and nut (11, Figure 6-15)
under right side of cab floor.
4.
Remove nut (12), bolt (13) and
nut (14).
5.
Disconnect governor control
linkage. Refer to paragraph
3-30, steps 4 and 5.
6.
Remove and discard cotter pin
(15) from bracket and pedal (22).
7.
Drive shaft (16) towards inner
frame and lubricate shaft (16)
with clean oil.
8.
Using suitable pliers, push shaft
(16) toward outside of vehicle
while depressing governor control
pedal.
9.
Remove items 17 thru 22 as an
assembly from bracket.
10. Remove cotter pin (17), pin (18)
and roller (19) from pedal (22,
Figure 6-16). Discard cotter pin
(17).
11. Remove two washers (20) and
roller bearings (21) from pedal
(22).
CLEANING
Clean all parts. Refer to Chapter 2.
Go to Sheet 3
6-28
Figure 6-14.
Figure 6-15.
Figure 6-16.
