TM 5-3805-261-34
BRAKES MAINTENANCE.
6-7.
Service Brake and Wheel Spindle Housing Assembly. (Sheet 3 of 4)
REMOVAL
WARNING
Weight of brake and wheel
spindle housing assembly is
350 lbs. Use adequate hoist
and sling for lifting.
Failure to follow this
procedure may cause INJURY.
If you are injured, seek
medical aid immediately.
4.
Install hoist and sling and
ratchet assembly on brake and
wheel spindle housing assembly
(8, Figure 6-12).
5.
Install two 7/8-14 THD nuts on
studs.
6.
Remove ten nuts (9) and lock-
washers (10).
7.
Using ratchet assembly, remove
brake and wheel spindle housing
assembly (8) from tandem drive
housing assembly.
8.
Place brake and wheel spindle
housing assembly (8) on wood
blocks.
9.
Remove two 7/8-14 THD nuts from
studs.
10. Remove hoist and sling and
ratchet assembly.
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter
2.
Go to Sheet 4
6-25
Figure 6-12.