TM 5-3805-261-34
BRAKES MAINTENANCE. (cont)
6-7.
Service Brake and Wheel Spindle Housing Assembly. (Sheet 2 of 4)
REMOVAL
NOTE
The following is a maintenance
procedure for the right
side, rear brake and wheel
spindle housing assembly.
The maintenance procedure for
the remaining three brake and
wheel spindle housing assemblies
is identical.
1.
Remove two nuts (1), lockwashers
(2) and guard (3) from brake and
wheel spindle housing assembly
(8, Figure 6-11).
NOTE
All hose and tube assemblies
must be tagged before removal
to aid in installation. Cap
all hose and tube ends to
prevent contamination.
2.
Loosen two nuts on tube assembly
(4).
3.
Remove tube assembly (4), elbow
(5), bolt (6) and plate (7) from
brake and wheel spindle housing
assembly (8).
Go to Sheet 3
6-24
Figure 6-11.