TM 5-3805-261-34
STARTING SYSTEM MAINTENANCE. (cont)
4-9.
Starting Motor (Delco-Remy). (Sheet 2 of 15)
DISASSEMBLY
1.
Remove plug (1) and preformed
packing (2) from housing (57,
Figure 4-35). Discard preformed
packing (2).
2.
Remove lock nut (3).
3.
Remove items 4 thru 10 as an
assembly from housing (57).
4.
Remove snap ring (4), retainer
(5), spring (6), retainer (7),
boot (8) and washer (9) from
shaft of plunger (10, Figure
4-36).
NOTE
All wire, cable and harness
assemblies must be tagged
before disconnecting to aid
in installation.
5.
Disconnect wire assembly (11,
Figure 4-37).
6.
Remove two plugs (12) and seals
(13) from housing (66). Discard
two seals (13).
7.
Remove two screws (14, Figure
4-38).
NOTE
Starting motor end frame and
housings must be matchmarked
before disassembly to aid in
assembly.
8.
Using scriber, matchmark end
frame (22) and housing (66).
Figure 4-38.
Go to Sheet 3
4-38
Figure 4-35.
Figure 4-36.
Figure 4-37.