CHARGING SYSTEM MAINTENANCE. (cont)

CHARGING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_304

CHARGING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_306

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
259

TM 5-3805-261-34 CHARGING SYSTEM MAINTENANCE. (cont) 4-5. Alternator (Bosch). (Sheet 10 of 12) ASSEMBLY (cont) 12. Install lockwasher (30) and nut (29, Figure 4-26) on terminal stud marked "B-". 13. Install stator (28) on frame (54) and aline matchmarks made earlier. 14. Position three stator (28) wires on diode assembly (39, Figure 4-25) terminal and solder. 15. Install bearing (26) and ring (25) in inner frame (27, Figure 4-24). 16. Position field coil (24) in inner frame (27) and install field coil (24) wire assembly. Secure in deep groove of inner frame (27) with caulking compound. 17. Install six lockwashers (23) and screws (22). 18. Install spacer (21, Figure 4-23). 19. Position rotor (20) in press. 20. Install rotor (20) in inner frame (27), supporting spacer (21). Use 24 volt (3 watt) test lamp of 3 watt resistor and connections to magnetize rotor (20). Go to Sheet 11 4-32 Figure 4-26. Figure 4-25. Figure 4-24. Figure 4-23.

Privacy Statement
Press Release
Contact