ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_177

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_179

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
133

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 3-19. Exhaust Manifold. (Sheet 3 of 3) INSTALLATION 1. Install three studs (15), four studs (14) and stud (13, Figure 3-80) to right side of cylinder head, if removed. Apply anti-seize compound to half of studs (15, 14 and 13) being installed in cylinder head. Tighten studs (15, 14 and 13) to 20 ft-lb torque. 2. Install four new gaskets (12) on studs (15, 14 and 13) in top, right side of engine. 3. Install manifold (11). 4. Install three washers (10), washer (9) and four nuts (8, Figure 3-79). Tighten four nuts (8) to 32 ft-lb torque. 5. Install four washers (7), two brackets (6), four washers (5) and nuts (4). Tighten four nuts (4) to 32 ft-lb torque. 6. Install shield (3), two washers(2) and bolts (1). NOTE Return 130G Grader to original equipment condition. End of Task 3-106 Figure 3-80. Figure 3-79.

Privacy Statement
Press Release
Contact