TM 5-3805-261-23-2
SIDESHIFT CYLINDER REPAIR - CONTINUED
0337 00
DISASSEMBLY - CONTINUED
8.
Remove cap (3) from rod (2).
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
ASSEMBLY
1.
Position cap (3) on rod (2).
2
3
397-2006
2.
Apply thin coat of clean oil to new seals (13, 14, and
10
15), new preformed packing (12), and ring (11).
3.
Use a seal installer to install new seals (13, 14, and 15)
15
in housing (10). Lip of seal (14) is toward inside of
14
housing. Lip of seal (13) is toward outside of housing.
13
11
4.
Install new preformed packing (12) and ring (11) to
12
housing (10).
397-2005
5.
Install housing (10) assembly on rod (2).
8
9
6.
Use a seal expander to install new seal assembly (8)
7
and ring (9) on piston (7).
397-2003
7.
Install piston (7) assembly on rod assembly (2).
2
8.
Apply thin coat of thread lubricant to threads of bolt
(5) and install washer (6), and bolt to end of rod (2).
5
Tighten bolt to 800 lb-ft (1,085 Nm).
6
7
397-2002
0337 00-4