TM 5-3805-261-23-2
REAR BLACKOUT LIGHT WIRING HARNESS REPLACEMENT - CONTINUED
0289 00
REMOVAL - CONTINUED
7.
Remove three nuts (20), washers (16), and clips (21).
8.
Remove and discard tie strap (17).
9.
Remove rear blackout light wiring harness (2) from clip (18).
10.
Remove rear blackout light wiring harness (2) from main wiring harness (19).
11.
Remove rear blackout light wiring harness (2) from machine.
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0021 00.
INSTALLATION
CAUTION
Do not position rear blackout light wiring harness against any rough surface. Failure to follow this procedure
may cause chafing.
NOTE
16
Route rear blackout light wiring harness
exactly as it was removed.
17
1.
Position rear blackout light wiring harness (2) on
machine.
2.
Connect rear blackout light wiring harness (2) to main
2
blackout light wiring harness.
3.
Install rear blackout light wiring harness (2) into clip
18
(18).
21
20
4.
Install new tie strap (17).
19
397-4091
5.
Install three clips (21), washers (16), and three nuts
(20).
0289 00-2