TM 5-3805-261-23-2
CYLINDER BLOCK HEAD ASSEMBLY MAINTENANCE - CONTINUED
0270 00
REMOVAL - CONTINUED
1.
Remove tube (1) from tube assembly (12) and atom-
1
izer (2) on top-left side of engine.
2.
Remove atomizer (2) from cylinder head (11).
234
3.
Disconnect tube assembly (3).
12
5
4.
Remove elbow (4).
6
5.
Disconnect tube assembly (8).
6.
Remove connector (9) and bushing (10).
7.
Loosen two clamps (6) on left side of engine.
8.
Remove hose (7) from pipe (5).
8
10 9
7
11
397-1299
9.
Remove bolts (18 and 19) and two bolts (17) from
14
15
front-left side of engine.
13
10.
Separate elbow (22) from cylinder block head (11) and
water pump (20).
16
17
11.
Remove and discard gaskets (16 and 21).
12.
Remove five screws (15), 14 bolts (14), and washers
18
(13) from top of cylinder block head (11).
11
22
21
19
20
397-1300
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
0270 00-2