TM 5-3805-261-23-1
BLADE LIFT CYLINDER REPLACEMENT - CONTINUED
0245 00
INSTALLATION
1.
Install two new sleeve bearings (29) on cylinder (9), if removed.
2.
Apply coat of grease to sleeve bearings (29).
3.
Install two new seals (28) on cylinder (9) with lip on seals facing outward.
CAUTION
Do not use impact-type drive to install two sleeve bearings.
4.
Install two sleeve bearings (27) into two caps (24).
24
27
27
24
397-1604
5.
Attach sling to cylinder (9). Tighten slack from sling.
6.
Position cylinder (9) to machine.
7.
Install cap (24), two washers (25), and two bolts (26)
to each side of cylinder (9) assembly. Leave bolts
loose.
8.
Apply coat of grease to ballstud of machine and two
inserts (18).
26
9.
Install two spacer plates (17) and one of two inserts
9
(18) on lower end of cylinder (9).
10.
Install other insert (18), two spacer plates (19), and
cap (20) with two new lockwashers (23) and bolts
(22).
17
NOTE
18
If removing two spacer plates, remove one
spacer plate from each side of ballstud.
19
Inserts should have a snug fit on ballstud.
20
23
21
11.
Move rod of cylinder (9) to check for free play
22
between ballstud and inserts (18) without allowing cap
397-1601
(24) to touch socket (25). Add or remove spacer plates
(17 or 19) as necessary.
0245 00-5
