TM 5-3805-261-23-1
BLADE LIFT CYLINDER REPLACEMENT - CONTINUED
0245 00
REMOVAL - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Blade lift cylinder weighs 175 lb (79 kg).
24
10.
With assistance, attach sling to cylinder (9). Remove
slack from sling.
25
9
11.
Remove two bolts (26), washers (25), and end cap
(24) from each side of blade lift cylinder (9) assembly.
12.
Remove blade lift cylinder (9) assembly from machine
and place in work area. Remove sling.
26
24 25 26
397-1602
NOTE
Each of these two sleeve bearings may have already been removed with caps.
13.
Use a puller to remove two sleeve bearings (27) and
27
seals (28). Discard seals.
28
14.
Use a puller to remove two sleeve bearings (29), if
29
necessary, from cylinder (9).
9
29
28
27
397-1603
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
0245 00-4