TM 5-3805-261-23-1
COOLANT TEMPERATURE AND ETHER START SWITCHES REPLACEMENT - CONTINUED
0114 00
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0021 00.
INSTALLATION
CAUTION
Be careful not to drop or hit the sens-
ing surface (7) of the coolant tempera-
ture switch on a rigid surface. Failure
to follow this caution may cause the
switch to work at an incorrect temper-
ature or not work at all.
Do not exceed 11 lb-in. (1.2 Nm)
7
when tightening screws of coolant
temperature switch. Damage to the
397-2096
switch may result if tightened too
much.
2
1.
Install coolant temperature switch (4) on top of water
pump (5) and tighten to 10 lb-in. (101 Nm).
3
1
2.
Connect two wire assemblies (1) to coolant tempera-
4
ture switch (4) and install two new lockwashers (3)
and screws (2).
5
397-2097
3.
Install radiator cap.
4.
Connect battery cables (WP 0125 00).
5.
Turn battery disconnect switch to ON position and start engine (TM 5-3805-261-10).
6.
Check for leaks. Stop engine.
7.
Install left side engine panel (WP 0182 00).
END OF WORK PACKAGE
0114 00-3
